You are here
1.5 inch Sealcoating Tank Agitation Shaft Flange Bearing F208
- Flange bearing for straight pipe/rod applications
- Accomodates upto 1-1/4" pipes or rods
- Allows for a small degree of off center installation
- Two set screws for a 3 point fastening contact
Looking to replace the shaft bearings on your BIGA sealcoating tank? Maybe you want to build your own tank agitation?
The F208 is a 1-1/2 inch diameter flange bearing that works great for end-to-end rotating shaft needs like the agitation of sealcoating tanks. If you've purchased one of our BIGA tanks in the past and need a replacement, these are the ones we use and will bolt up without a problem.
If you're building your own, we've used these bearings for well over a decade on our sealcoating tanks and haven't had any problems with them outside of the normal wear-and-tear. Keep in mind, the OD of the shaft pipe or rod can not exceed 1-1/2" and we actually recommend using a shaft that is slightly smaller for easier fitment.
The F-2XX series flange bearings are designed to rotate within their housing which gives you some lee-way on positioning the shaft and bearings on each end. For obvious reasons, we recommend that they are installed as straight and level as possible, but in case you're a little off, these bearings will give you a small amount of forgiveness if things aren't perfect.
For maintenance, we recommend greasing the bearings at least once per year through the installed grease zerk, and they should last just fine for a long time.
Included is the cast-iron flange and pre-installed UC type bearing.
While this is advertised as a sealcoating shaft seal bearing, this part can be used in a wide variety of industrial applications.
Mounting hardware not included.
Note: Brand of manufacture may vary.
1-1/2" Flange Bearing Rubber Gasket Seal
Cast iron housing
UC style bearing that roates within the flange bracket
Includes grease zerk for easy maintenance
Two 120º offset set screws create a 3-point contact
You Might Like
Shaft OD Diameter (max)
Flange Bolt Diameter
Flange Bolt Center Spacing